MAINTENANCE GUIDE & SERVICE MENU

• Mercedes-Benz Synthetic Motor Oil Replacement
• Oil filter replacement
• All fluid level checks and corrections are dependent on factory-recommended service intervals for your vehicle’s year and model.
• Tire inflaction check and correction
• Brake component inspection
• Reset maintenance counter
• Adhere to all require elements listed by model and year specific model as indicated on the corresponding service sheet for Mercedes-Benz Maintenance Systems in the USA.

• Mercedes-Benz Synthetic Motor Oil Replacement
• Oil Filter Replacement
• Cabin dust/combination filter replacement
• Brake fluid exchange
• All fluid level checks and corrections are dependent on factory-recommended service intervals for your vehicle’s year and model.
• Tire inflation check and correction
• Brake component check
• Reset maintenance counter
• Adhere to all require elements listed by model and year specific model as indicated on the corresponding service sheet for Mercedes-Benz
  Maintenance Systems in the USA.

• Pressure testing the system for leaks in the cooling system and cap
• Inspecting cooling system hoses, freeze plugs, and radiator for deterioration
• Drain and refill system with Mercedes-Benz approved antifreeze/coolant

Genuine Mercedes-Benz Brake Parts are designed and tested at the high speeds and extreme stresses of the German Autobahn ensuring their ability to bring you and two tons of accelerated machinery to a safe and sure stop, time and time again, under both routine and emergency conditions. Brake wear is a normal and necessary part of bringing your vehicle to a safe and reliable stop. The material and composition of Mercedes-Benz brake pads are specially developed to provide a balance between high-speed braking and brake-dust reduction because, after all, there may be no more important function of your Mercedes-Benz then the effectiveness of its brakes when called upon in an emergency.

• Flush all moisture contaminated hydraulic fluid from the brake system
• Remove and clean the master cylinder reservoir
• Check system for leaks
• Road test

For older Mercedes-Benz models, continuing maintenance is the key to longevity. We recommend the following maintenance at the 45,000, 75,000, and 105,000 marks.

• Change oil and replace filter with genuine Mercedes-Benz product
• Inspect for leaks and general condition of all components, lines and hoses on the engine, the transmission, level control, steering system and fuel and brake systems
• Inspect and adjust drive belts.
• Clean and inspect air cleaner element.
• Rotate tires
• Brake inspection, including rotor measurement using micrometer and a report on the estimated remaining life
• Parking brake adjustment
• Check all exterior and interior lamps and windshield wiper inserts.
• Lubricate throttle shafts, door hinges and locks.
• Function check of most components.

For older Mercedes-Benz models, continuing maintenance is the key to vehicle longevity. We recommend the following maintenance every two years, or at the 60,000, 90,000, and 120,000 mile markers.

• Oil Change and Filter Replacement using Genuine Mercedes-Benz parts
• Check and Top Off All Fluid Levels (dependent on your vehicle’s calculated service intervals)
• Check Tire Pressure and Inflate as Needed
• Inspect Brakes

Adhere to all required elements listed by model year and specific model as indicated on the corresponding service sheet for Mercedes-Benz Maintenance Systems in the USA.

Recommended every 5,000

Lubrication Service (except V12, AMG^®). Service includes draining engine crankcase and refilling with Mercedes-Benz Genuine Engine Oil. Replace engine oil filter. Visual brake inspection. Check and replenish all fluid levels. Check belts and hoses. Check interior and exterior lights.

• Tire Rotation
• Tire Rotation and Balance
• Four Wheel Computerized Alignment

• Drain oil from transmission pan and torque converter.
• Remove, examine, and clean transmission pan.
• Replace the transmission’s filter and pan gasket.
• Refill transmission with required oil.